HP Designjet 5000 series printer - User's Guide

Media & InkIntroduction Front-Panel Other
Index
Solutions
The Front-Panel Setup Menus Consumable Menus Internal Prints Navigation
Message
Descriptions
Printer
Options
Sheet misaligned. Lift
lever to align with blue
line or to remove media.
This means that the media
has not been fed into the
printer straight.
Reload the media making sure
that the edges of the media
are parallel and that it is
straight when you feed it in.
Align the media coming out
from the printer with the media
going into the printer, see
Loading Roll Media
Sheet required for
calibration
The printer is prompting you
to load media into the
printer before it can perform
a calibration.
To see an animation on the
loading procedure see
Loading Roll Media
Switch power off The printer is prompting you
to isolate the printer from
the power supply.
Switch off the printer using the
power switch located out the
rear of the printer. See
Switching Your Printer On and
Off
Switch power off Check
media path
There is a media jam in the
printer.
Clearing a Media Jam
Switch power off Check
printhead path
There is a media jam in the
printer.
Switch the printer off and clear
the blockage.
see Clearing a Media Jam
Status Description Procedure