HP Designjet 3D Printer Series - User Guide

Maintenance

Figure 39 Head cover tab locations

9. Remove tips:

a. Use 7/64 T-Handle Allen wrench to loosen the heater block

screws three to four full turns counterclockwise - or until the top of

the screws are flush with the metal cover. DO NOT remove the

screws entirely. See Figure 40.

Figure 40 Tip Removal

b. Use needle nose pliers to grasp the stainless steel shield of the

tip.

c. Pull the tip shield toward you, then pull down to remove the tip

from the heater block. Discard the used tip. See Figure 41.

Press tabs in to remove

head cover

Head cover

Loosen but do not

remove heater

block screws

Loosen but do not

remove heater

block screws