HP Designjet 3D Printer Series - User Guide

35
Maintenance
500 Hour maintenance
Preventive Maintenance Alerts will be displayed on the workstation at the 500 hour time interval
as a reminder to perform preventive maintenance. See Figure 27.
Figure 27 Preventive Maintenance Alert
Tip wipe assembly
The tip wipe assembly should be replaced approximately every 500 hours.
1. Completely power down the printer.
2. Move the head to the right of the printer to gain access to the tip wipe assembly.
Figure 28 Move the toggle head to the right
3. Remove the tip wipe assembly by lifting the assembly up and out of the printer. Discard this
tip wipe assembly. See Figure 29.