HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

Message Explanations and Actions
81
Calibrate error
Continue→
The calibration print was loaded incorrectly and it could not be measured.
Press ↓ to continue, then reload the print for measurement. Follow front panel
instructions.
Calibrate Yes →
Color No →
You are using sheet media and color calibration is on. The printer is asking you
if you want to calibrate the color for the loaded media.
Press
↑ for yes.
Press ↓ for no.
Calibration done
Continue→
Accuracy calibration is complete.
Press ↓ to continue.
Cancelled
Continue→
You have just cancelled the last print or function.
Press ↓ to continue.
Check ■■*■
Close right door
The printer has detected an error in the printhead cleaners indicated by the
stars.
Reseat (do not replace) the indicated cleaners. When you have done so, close
the right door of the printer. See 70, Checking the Printhead Cleaners.
Check ink cartridges
■■❏■ Abort →
The printer has detected an error in the cartridges indicated by the empty
squares.
Reseat (do not replace) the indicated cartridges or press the ↓ key to terminate
the procedure. In this case, you will not be able to print, and you may later
resume checking the ink system by pressing the Replace Ink System button. See
72, Checking the Ink Cartridges.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 81 Tuesday, July 28, 1998 5:31 PM