HP DC04 SAN Director Switch Hardware Reference Guide

Table 18 Critical information checklist
Configuration information
Location of config-switch.txt file:
Location of config-miscinfo.txt file:
IP address, subnet mask:
WWN for DC04 SAN Director:
SAN profile
Location of SANbefor.txt file:
Notes regarding nsshow output:
Notes regarding nsallshow output:
Notes regarding switchshow output:
Notes regarding fabricshow output:
Output from supportshow command
Location of spptshow.txt file:
Notes regarding supportshow output:
Information about the new chassis
New Factory Serial Number:
New Serial Number (if available):
To record critical DC04 SAN Director and SAN information:
1. Open a Telnet session and log in to the DC04 SAN Director as admin. The default password
is password. Enable the logging function on your Telnet or serial console connection.
2. Back up the current configuration.
Enter the configUpload command, and then enter the requested information at the prompts.
This command uploads the DC04 SAN Director configuration to the customer-defined FTP
server, making it available for downloading. For more information about this command, see
the Fabric OS Command Reference.
rsl8-st03-dcx-1:admin> configupload
Protocol (scp or ftp) [ftp]: ftp
Server Name or IP Address [host]: 123.123.123.123
User Name [user]: Admin24
File Name [config.txt]: config-switch0.txt
Password:
Upload complete
rsl8-st03-dcx-1:admin>
86 Replacing DC04 SAN Director FRUs