HP DC04 SAN Director Switch Hardware Reference Guide

3. Verify that HA is enabled using the haShow command. The command output includes HA
Enabled Heartbeat Up and HA-state in sync.
If HA is not enabled, POST is not complete, or the CP blades have not achieved redundancy,
wait one or two minutes and re-enter the command until you can verify that redundancy has
been achieved.
4. Enter the slotShow command. The command output shows the new CP blade as ENABLED:
swDir:admin> slotShow
Slot Blade Type ID Status
---------------------------------
1 UNKNOWN VACANT
2 SW BLADE 55 ENABLED
3 CORE BLADE 52 ENABLED
4 CP BLADE 50 ENABLED
5 CP BLADE 50 ENABLED
6 CORE BLADE 52 ENABLED
7 UNKNOWN VACANT
8 SW BLADE 55 ENABLED
swDir:admin>
5. Enter the firmwareShow command to determine the Fabric OS version.
The following example shows sample output for the firmwareShow command:
swDir:admin> firmwareShow
Local CP (Slot 7, CP1): Active
Primary partition: v6.2.0
Secondary Partition: v6.2.0
Remote CP (Slot 6, CP0): Standby
Primary partition: v6.2.0
Secondary Partition: v6.2.0
Note: If Local CP and Remote CP have different versions
of firmware, please retry firmwaredownload command.
swDir:admin>
6. If the firmware version on the replacement blade does not match that on the active CP blade,
bring the replacement blade to the same firmware level as the active blade.
7. Enter the firmwareDownload -s command to download the firmware to one of the CP
blades. Enter all requested information (use default values):
swDir:admin> firmwaredownload -s
Server Name or IP Address: 192.168.100.1
User Name: user
File Name: /software/v6.2.0/release.plist
Password: ********
Do Auto-Commit after Reboot [Y]:
Reboot system after download [N]:
Firmwaredownload has started.
2007/07/03-14:59:21, [SULB-1001], 923,, WARNING, DC Director,
Firmwaredownload command has started.
Start to install packages......
dir ##################################################
ldconfig ##################################################
glibc ##################################################
bash ##################################################
readline ##################################################
terminfo ##################################################
termcap ##################################################
setup ##################################################
74 Replacing DC04 SAN Director FRUs