HP DC04 SAN Director Switch Hardware Reference Guide

To set the domain ID:
1. Enter the switchDisable command to disable the DC04 SAN Director.
2. Enter the configure command.
3. Enter y at the Fabric parameters prompt:
Fabric parameters (yes, y, no, n): [no] y
4. Enter a unique domain ID:
Domain: (1.239) [1] 3
5. Complete the remaining prompts or press Ctrl+D to accept the settings and exit.
6. Enter the switchEnable command to re-enable the DC04 SAN Director.
Setting the date and time
The date and time settings are used for logging events. Switch operation does not depend on the
date and time; a switch with an incorrect date and time value still functions properly. However,
because the date and time are used for logging, error detection, and troubleshooting, they should
be set correctly.
Setting the date
To set the date:
1. If necessary, log on to the DC04 SAN Director by Telnet using the admin account.
2. Enter the date command using the following syntax:
date "mmddHHMMyy"
Where:
• mm is the month; valid values are 01 through 12
• dd is the date; valid values are 01 through 31
• HH is the hour; valid values are 00 through 23
• MM is minutes; valid values are 00 through 59
• yy is the year; valid values are 00 through 99 (values greater than 69 are interpreted
as 1970 through 1999, and values less than 70 are interpreted as 2000-2069)
For example:
switch:admin> date
Fri Sep 26 17:01:48 UTC 2008
switch:admin> date "0926123008"
Fri Sep 26 12:30:00 UTC 2008
switch:admin>
42 DC04 SAN Director login and configuration