HP DC04 SAN Director Switch Hardware Reference Guide

tip /dev/ttyb -9600
When the terminal emulator application stops reporting information, press Enter. The following
login prompt appears:
CP0 Console Login:
6. Log in to the DC04 SAN Director as admin. The default password is password. At the initial
login, the user is prompted to enter new admin and user passwords.
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
Password was not changed. Will prompt again at next login
until password is changed.
swDir:admin>
7. (Optional) Modify passwords.
Passwords can be 8 to 40 characters long. They must begin with an alphabetic character.
They can include numeric characters, a period (.), or an underscore (_). Passwords are
case-sensitive, and they are not displayed when you enter them on the command line. Be sure
to write down the new password and keep this information in a secure location.
To skip modifying the password, press Ctrl+C. For more information on passwords, see the
Fabric OS Administrator's Guides.
Configuring IP addresses
The DC04 SAN Director requires three IP addresses, which are configured using the ipAddrSet
command. IP addresses are required for both CP blades (CP0 and CP1) and for the single logical
switch (shown as SWITCH under the ipAddrShow command) in the DC04 SAN Director.
Default IP addresses and password
The default IP addresses and host names for the DC04 SAN Director are:
• 10.77.77.75 / CP0 (the CP blade in slot 4 at the time of configuration)
• 10.77.77.74 / CP1 (the CP blade in slot 5 at the time of configuration)
The default password is password.
IMPORTANT: Resetting an IP address while the DC04 SAN Director has active IP traffic such as
Data Center Fabric Manager, Fabric Watch, SNMP, or other applications can cause traffic to be
interrupted or stopped.
To configure the IP addresses for both CP blades (from the active CP blade):
1. Log in to the active CP as admin using the serial cable connection.
2. Set up the DC04 SAN Director IP address by entering the ipaddrset -chassis command:
swDir:admin> ipAddrSet -chassis
Enter the information at the prompts. Specify the -chassis IP address. There is no -sw 1
IP address.
NOTE: The addresses 10.0.0.0 through 10.0.0.255 are reserved and used internally by
the DC04 SAN Director. External IPs must not use these addresses.
3. Set up the CP0 IP address by entering the ipaddrset -cp 0 command:
swDir:admin> ipAddrSet -cp 0
Enter the configuration information at the prompts.
Configuring IP addresses 39