HP DC04 SAN Director Switch Hardware Reference Guide

Figure 17 DC04 SAN Director to DC SAN Director ICL cabling (configuration 1)
5. ICL connector (ICL 1)1. Chassis 1 (DC04)
6. ICL connector (ICL 0)2. Core switch blades (CR4S-8)
7. ICL cables3. Control processor blades (CP8)
8. Chassis 2 (DC SAN Backbone)4. Port blades
NOTE: For clarity, the two sets of cables are drawn differently in Figure 18 (page 36) and
Figure 19 (page 37). One set is connected to the blades in the low-order slots (slot 3 in the DC04
SAN Director and slot 5 in the DC SAN Director) and the other set is connected to the blades in
the high-order slots (slot 5 in the DC04 SAN Director and slot 8 in the DC SAN Director). Keeping
the sets apart minimizes cable confusion.
Using the optional HP DC SAN Director Inter-Chassis Link cable kit 35