HP DC04 SAN Director Switch Hardware Reference Guide

1. Before installing the DC04 SAN Director in the cabinet, remove the 10 flathead 6-32 screws
located on both the left and right side chassis panels. See Figure 11 (page 28).
2. Install both side plates using the ten 6-32 panhead screws supplied with the kit.
NOTE: The left and right side plates are different. The left side and right side plates are
marked “A” and “B” respectively. See Figure 11 (page 28).
NOTE: The side plates have five sets of discrete holes, marked 27 through 31. Use the holes
that correspond with the cabinet’s rail-to-rail depth. See Table 8 (page 27). Tighten the screws
to 10 in/lb.
3. Install the DC04 SAN Director in the cabinet.
4. Install the clip nuts or nut retainers.
The clip nuts are used with cabinets that have square holes, and nut retainers are used with
cabinets that have round holes. The locations of the clip nuts or nut retainers match the location
for the port-side rack brackets.
5. Secure the L-brackets to the cabinet rails using the six 10-32 panhead screws with square
cone washers supplied with the kit. Tighten the screws to 32 in/lb.
NOTE: The left and right side brackets are different. The left side and right side L-brackets
are marked with A and B respectively. See Figure 12 (page 28).
6. After mounting the L-brackets to the rails, secure them to the side plates using the 18 10-32
panhead screws with square cone washers supplied with the kit. See Figure 12 (page 28).
Tighten the screws to 32 in/lb.
Table 8 Cabinet rail-to-rail depths
3130292827Column ID
30.5–3129.5–30.528.5–29.527.5–28.527–27.5Rail-to-rail depth (in)
Figure 10 DC04 SAN Director shipping brackets (left side)
Installing the DC04 SAN Director in a rack 27