HP DC04 SAN Director Switch Hardware Reference Guide

NOTE: The screws, clip nuts, and retainer nuts used to secure the DC04 SAN Director to the
cabinet are provided in the DC04 SAN Director hardware accessory kit.
To install the DC04 SAN Director in the cabinet:
1. Remove the chassis door from the DC04 SAN Director. See Removing the chassis
door (page 65).
2. Use a lift to raise the chassis to the correct level. Position the lift as close as possible to the
rack.
3. If applicable, lock the wheels on the lift.
4. Carefully lift the DC04 SAN Director and slide it into the cabinet.
5. Secure the DC04 SAN Director to the cabinet using six 10-32 screws with washers. See
Figure 9 (page 26).
• For rails with round holes—Use the clip nuts (F in Figure 4 (page 22)) on the rails for
securing the 10-32 screws.
• For rails with square holes—Use the retainer nuts (G in Figure 4 (page 22)) on the rails
for securing the 10-32 screws.
Tighten the screws according to the specifications listed in Table 7 (page 23).
Figure 9 Installing the DC04 SAN Director in the cabinet
6. Reinstall the chassis door. See Installing the chassis door (page 65).
7. Install the cable management finger assembly. See Installing a cable management finger
assembly (page 66).
Installing the DC04 SAN Director shipping brackets
This section describes how to install the DC04 SAN Director shipping brackets. (See Figure 10 (page
27).) These brackets are required when the DC04 SAN Director is shipped installed in a cabinet.
26 DC04 SAN Director Installation