HP DC04 SAN Director Switch Hardware Reference Guide

Table 6 Rack mount kit contents (continued)
QuantityDescriptionItem
1210-32 x 1.27 cm (0.5 in) Phillips screw (blue Loctite on
threads)
D
1210-32 x 1.60 cm (0.63 in) Phillips screw with square
cone washer
E
810-32 clip nut for cabinets that have rails with round holesF
810-32 retainer nut for cabinets that have rails with square
holes
G
12Alignment washer for cabinets that have rails with square
holes
H
26-32 x 0.635 cm (0.25 in) Phillips screwI
Figure 4 Rack mount kit hardware
Torque requirements
Use the torque settings listed in Table 7 (page 23) when tightening screws that secure the rack
mount kit and DC04 SAN Director to the equipment cabinet.
22 DC04 SAN Director Installation