HP DC04 SAN Director Switch Hardware Reference Guide

Table 5 DC04 SAN Director shipping carton contents (continued)
• Blade slot filler panels (for slots not filled by blades)
• Port-side exhaust kit
• Shipping bracket kit
• WWN cards
• WWN bezel (logo plate)
• Power supplies
• Blower assemblies
• Vertical cable management fingers
• Chassis door
The accessory kit includes:
• HP product documentation
• ESD grounding strap
• RS-232 serial cable, with an adapter at one end to provide an RJ-45–style connector
• HP B-series 2G USB Drive
IMPORTANT: Order SFP transceivers separately. The DC04 SAN Director supports SWL, LWL,
and ELWL transceivers. See http://www.hp.com for more information on supported transceivers.
Installing the DC04 SAN Director in a rack
Air flows into the DC04 SAN Director through its non-port side and out through the exhaust vent
on the side of the unit. The port side exhaust kit is designed to route the airflow out the exhaust
vents on the port side of the unit while mounted in the equipment cabinet. This section provides
instructions for installing a DC04 SAN Director in a 48.26-cm (19-in) EIA cabinet using the port-side
exhaust kit for cabinets with rail-to-rail depth of 68.58 to 78.74 cm (27 to 31 in).
CAUTION: Use safe lifting practices when moving the DC04 SAN Director. A fully-populated
DC04 SAN Director (four FC8-64 port cards, 512 ports) weighs approximately 159.2 kg (351
lb), and requires a hydraulic or assisted lift to install.
Allow approximately one hour to unpack and install the DC04 SAN Director in a cabinet. The
following tools are required to install the rack mount kit:
• Torque wrench with #2 Phillips screwdriver tip
• Flathead screwdriver
• Hydraulic or assisted lift with a minimum raise of 140 cm (55 in) and a minimum capacity of
113 kg (250 lb)
Rack mount kit contents
Table 6 (page 21) and Figure 4 (page 22) identify the hardware provided in the 4U rack mount
kit that ships with the DC04 SAN Director.
Table 6 Rack mount kit contents
QuantityDescriptionItem
1Top railA
1DuctB
1ShelfC
Installing the DC04 SAN Director in a rack 21