HP DC04 SAN Director Switch Hardware Reference Guide

Table 25 DC04 SAN Director power specifications
ValueSpecification
Range: 85–264 VAC Auto-volt, Nominal: 100 to 240 VACInput voltage
47–63 Hz; Nominal: 50–60 HzInput frequency range
Low line (85–132 VAC), 1,000 W; High line (180–264
VAC), 2,000 W
Power supply output (each)
20 A maximum, peakAC inrush current
AC power consumption is configuration-specific. A system
with four FC8-48 port blades (loaded with 1 W SFPs), two
System power consumption
CP8 blades, two CR4S-8 blades, and two blower
assemblies consumes 841 W.
If you plan to upgrade your 8 Gb DC04 SAN Director chassis to a 16 Gb platform, use
Table 26 (page 104) to determine the power requirements for your HP SN8000B 4-Slot SAN Director
Switch configuration.
Table 26 Typical power supply requirements for the HP SN8000B 4-Slot SAN Director
Comments
@200-240 VAC
nl
@110 VAC
nl
TypeBlade (redundant configuration)
(redundant
configuration)
1+1 redundancy with 110 or
200-240 VAC power supplies
Two power suppliesTwo power suppliesPort bladeFC16-32
nl
FC8–32E
nl
(96 ports maximum
with QSFP ICLs)
200-240VAC: 1+1 power
supplies
Two power suppliesNot supportedIntelligent
blade/
Combination
FC16–32,
FC16–48
nl
FC8–32E, FC8–48E
nl
FC8–64, FS8–18
nl
FX8–24, FX8–24E
nl
(Any combination of
8Gb or 16 Gb
ports and intelligent
blades with QSFP
ICLs)
nl
Power cords
The power cords provided with the DC04 SAN Director are specific to the country where it is
installed. For each of these types of power cords (see Table 27 (page 104)), the end that connects
to the Director chassis has an IEC 60320/C19 cable connector. The two AC power receptacles
on each chassis are equipped with IEC 60320/C20 power connectors.
Contact HP to order a power cord.
CAUTION: Never use the power cord supplied with your DC04 SAN Director for other products.
Table 27 Power cord types (international)
Plug style
Country
C20
20A-250V 12
IEC-60309
32A-6h,
230V
AS 3112
Australia/New
Zealand
BS-1363ACEE-7/7
“Schuko”
Continental
Europe
NEMA L6-20
USA,
Canada,
Mexico,
NEMA 5–20P
125V only
USA, Canada,
Mexico, other
locations
AWG connect
to in-cabinet
power stripother
locations
104 Technical specifications