HP DC SAN Backbone Director Switch Hardware Reference Guide

Figure 8 Aligning the DC SAN Director door with the chassis
Figure 9 Inserting DC SAN Director door on chassis ball studs
2. Mounting hardware1. Ball stud on chassis (outside view of door)
3. Ball stud on chassis (inside view of door)
Powering on the DC SAN Director
CAUTION: Use the supplied power cords. Ensure the facility power receptacle is the correct type,
supplies the required voltage, and is properly grounded.
To power on the DC SAN Director:
1. Connect the AC power cords to the power supply assemblies. One to four power cords are
required depending on electrical service.
28 DC SAN Director installation