HP DC SAN Backbone Director Switch Hardware Reference Guide

Table 26 Power cord types (international) (continued)
Plug style
Country
C20
20A-250V 12
AWG connect
to in-cabinet
power strip
only. All
locations
IEC-60309
32A-6h,
230V
AS 3112
Australia/New
Zealand
BS-1363ACEE-7/7
“Schuko”
Continental
Europe
NEMA L6-20
USA,
Canada,
Mexico,
other
locations
NEMA 5–20P
125V only
USA, Canada,
Mexico, other
locations
XXXUnited
States
XXXVenezuela
XXYugoslavia
Power cords (Japan, Denan)
Environmental requirements
Table 27 (page 109) lists the environmental operating ranges for the DC SAN Director. The
requirements for non-operating conditions are also provided for acceptable storage and
transportation environments.
Table 27 DC SAN Director environmental requirements
Acceptable range during
nl
Acceptable range during operationCondition nonoperation
-40° to +70°C outside switch (-40° to
158°F)
10° to 40°C outside switch (50° to 104°F)Ambient temperature
10% to 93% RH noncondensing, at 70°C20% to 85% RH noncondensing, at 40°C,
with maximum gradient of 10% per hour
Humidity
0 to 12 km (40,000 ft) above sea levelUp to 3 km (10,000 ft) above sea levelAltitude
33G, 11 ms duration, half-sine wave20G, 11 ms duration, half-sine waveShock
2.4G p-p, 5–500 Hz at 1.0 octave/min1G p-p, 5–500 Hz at 1.0 octave/minVibration
None required350 cu ft/min (0.00059 cu m/hr)Air flow
Not applicable1,440 W or 4,914 BTU (eight FC8-48
blades and two CP8 blades)
Heat dissipation
Environmental requirements 109