Data Protector NDMP Integration Quickstart Guide

7
5. Click Create in order to create the virtual tape library according to your specification.The creation
of the virtual library will make the new library appear on the StoreOnce management GUI.
6. To verify the interface information, select the Interface Information tab in the lower part of the
screen:
Figure 4: Interface Information
Note: ”Device Serial Number” and “World Wide Node Name” are configuration details that are
used in further configuration tasks such as setting up FC SAN zones on the SAN router or
identifying tape devices attached to the DSP (NAS appliance).
DSP on NAS appliance (primary storage)
HP X9000 models
The HP X9000 Network Storage System requires the following steps to configure the cluster for NDMP
backup. The steps are shown on Figure 5, which depicts a management GUI of an X9000 Network
Storage Gateway consisting of two nodes: