Data Protector NDMP Integration Quickstart Guide

5
3. Ensure that you have correct Data Protector licensing for NDMP backups:
 NDMP LTU for all platforms: 1xTB B7022BA, 10xTB B7022DA, 100xTB TD186AA
 Appropriate number of library slots LTU: 1x 61-250/unlimited slots B6957BA/B6958BA,
upgrade to unlimited slots B6958CA
 Appropriate number of tape drive LTU for SAN, UNIX, NAS: B6953AA
 Alternatively, licensing to tape drive LTU
 Advanced Backup to Disk LTU for all platforms: 1xTB B7038AA, 10xTB B7038BA, 100xTB
B7038CA
4. Configure the NDMP client.
5. Configure the backup library on the Data Protector Cell Manager.
Figure 2: NDMP 2-way backup topology
Note: Data Protector supports library sharing in a SAN environment.
Configuration steps
The following sections describe the steps necessary for properly configuring the backup target
(StoreOnce), the DSP (NAS appliance), and the DMA (NDMP client and Library configuration on the
Cell Manager). They do not cover SAN and LAN configuration aspects. All DMA (NDMP client)
settings are non-modified standard settings.
StoreOnce Backup System (secondary storage)
The StoreOnce backup system requires five steps to create and configure a new virtual tape library
(VTL). These are shown in Figure 3, which depicts the StoreOnce management GUI: