HP StorageWorks DAT Internal Autoloader Getting Started Guide

Internal autoloaders - contents

Pre-Installation

Before you start page 3

Backup software and drivers page 5

Using the CD-ROM page 7

Checking the SCSI connection page 9

Installing the autoloader

Step 1: Check the autoloader’s SCSI ID page 11

Step 2: Check the option switch value (Sun systems only) page 13

Step 3: Set the configuration switches (UNIX systems only) page 15

Step 4: Prepare the mounting bay page 17

Step 5: Attach mounting hardware page 19

Step 6: Attach Y-cable and install drive page 21

Step 7: Attach power and SCSI cable page 23

Step 8: Secure the autoloader page 25

Step 9: Verify installation page 27

Using the autoloader

Your HP StorageWorks DAT autoloader page 31

Use the correct media page 35

Using HP OBDR page 41

Diagnostic tools page 43

Optimizing performance page 44

Troubleshooting page 45

Other sources of information page 51

Replacing your autoloader page 52

autoload_master-frame6.fm Page 1 Monday, December 29, 2003 9:28 AM