Rail Kit Install Instructions (734750-001, March 2014)

7. Slide the enclosure into position on the rails (1).
Secure the chassis into the rack by tightening the
captive CTO screw behind the latch on the front left
and right bezel ears of the chassis (2).
CAUTION: The front CTO screw must be
attached at all times when racked.
8. The rear ends of the rails have a CTO bracket that
must engage with the enclosure in order to secure
it to the rails.
Align the CTO bracket to the corresponding rear
slot into the chassis. The movable bracket can be
slid forward or back to correct position. The
provided screw will secure the bracket and chassis
to the rail.
NOTE: The provided screw must be secured
tightly. HP recommends using a T25 driver.
9. When cabling the device, use holes provided in the
rear rack rails, install tie wraps, and route external
cable(s) as required.
Page 2