HP StoreOnce B6200 Maintenance and Service Guide (February, 2014)

Figure 3 Hardware Details (GUI)
3. Make a note of the relevant information on this page. In particular, you need the:
• Serial Number to confirm that you have replaced the correct component
• Firmware Version to confirm that the replacement component is running the same firmware.
System health check (HP Support users only)
From software revision 3.2.0 a system health check can be run from the hpsupport user level. To
run this report, you must be in the Linux shell and you must have a Limited Time Password, see
Software tools (page 14).
1. At the StoreOnce CLI prompt, type : hpsupport <password>
2. Enter shell to access the Linux shell, then type:
/integration/scripts/sys_eng/hardware_summary.sh email
There is an option to send the output to the SMTP/email accounts setup on the HP B6200
Backup System. If you wish to use this option, SMTP and email must be set up from the GUI.
See the HP StoreOnce B6200 Backup System user guide.
Use the option ‘–h’ to check other options available.
System health check (HP Support users only) 19