HP StoreOnce Backup System CLI Reference Guide

hardware reboot
NOTE: This command applies to multi-node products.
Description of Command Function
Reboots StoreOnce appliance nodes. If a file server node is defined in the command entry, only
that node is rebooted.
Command Syntax
hardware reboot [NODEX]
Command Authority
Administrator
Command Object Requirements
NODE X – As an option, this can be used to define an individual file server node. X is a unique
numeric index. NODEX is a label uniquely defining the hardware component. It is assigned during
the initial automatic hardware initialization and configuration. A complete list of the NODEX labels
can be obtained using the hardware show node status command (see “hardware show
node status” (page 80)). If a file server node is defined, only that node is rebooted. If no nodes
are defined, all the nodes in the appliance are rebooted. This command should be run for both
nodes within the couplet pair (i.e., 1 and 2; 3 and 4; 5 and 6; 7 and 8) and should not be run
for an individual node on its own.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
• The command entry must conform to command syntax.
• At least one system with an active CLI must exist.
• If a file serving node is defined in the command entry, the defined node must be powered on.
Successful Command Output
Upon successfully sending the reboot request, the following is displayed:
reboot request successfully sent
NOTE: This message only indicates the success for the reboot request. The hardware show
node status command (see “hardware show node status” (page 80)) must be entered to verify
that server nodes rebooted correctly. Also, if the reboot applies to the node currently supporting
the CLI interface, the session terminates following this command.
Command Operation during Abnormal Conditions
• If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• If the defined node is not powered up, the following is displayed:
Command Failed – NODEX is not rebooted, where NODEX is the file server node
defined for reboot in the command entry.
Example
# hardware reboot
reboot request successfully sent
74 Alphabetical List of Commands and Details