HP StoreOnce Backup System CLI Reference Guide

config save devices
Description of Command Function
Saves the device configuration to the configuration jail directory using the standard naming
convention of devconfig_<cluster ID and serial number> <date and time
stamp>.zip. (A configuration file listed by this may not be a valid configuration file. The user
must manage the transfer of valid configuration files into the config directory.)
NOTE: This command only works if storage systems are in a Good state. If, for example,
replication is out of sync and the storage system status is something other than Running state, the
config save devices command fails.
For more information about the configuration save and restore process, see the HP StoreOnce
Backup System User Guide (single-node or multi-node, depending on your product). See also
“config restore devices” (page 52).
Command Syntax
config save devices
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, the following is displayed:
Configuration Save Started
From the CLI user prompt, enter the config show list command to see the saved configuration
files.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
• Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• Errors generated by the d2d serviceset save process are prefixed Command Failed
and displayed as CLI error messages.
Example
Configuration Save Started
Enter command "config show list devices" to see the saved configuration files
Command Successful
config save devices 55