HP StoreOnce Backup System CLI Reference Guide

◦ Command Failed – The system hardware does not match the
configuration file (service set does not exist)
◦ Command Failed – Configuration file has been modified (use of
the force parameter will override this check)
• If the force parameter is set, the following message is displayed before executing the command:
The validity of the configuration file is not being checked. After
command execution, verify devices have been configured on system as
expected
• Errors generated by the d2d serviceset restore process are prefixed Command Failed
and displayed as CLI error messages.
Example
# config restore devices saved-devices-config
Command Successful
config restore devices 53