HP StoreOnce Backup System CLI Reference Guide

system show config
Description of Command Function
Displays information on the StoreOnce appliance system configuration.
Command Syntax
system show config
Command Authority
Operator and Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, the following is displayed:
D2D appliance name: APPLIANCE-NAME
Product Serial Number: XXXXXXXX
CLI output: OUTPUT
where APPLIANCE-NAME is the parameter defined using the command system set
description (see “system set description” (page 191)) and OUTPUT is the text format defined
using the command system set clioutput (see “system set clioutput” (page 187)).
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Examples
HP StoreOnce B6200:
# system show config
Cluster ID : hp984be10c4430
Description : hp984be10c4430
Product Class : HP B6200 StoreOnce Backup System
Hardware Type : Physical
Couplets
========
Couplet Id
----------
1
CLI output : text
Page control : Off
HP StoreOnce 6500:
# system show config
CLUSTER ID: d2d485647867b2
Description: NameOfD2D
system show config 195