HP StoreOnce Backup System CLI Reference Guide

The following configuration steps will be performed:
-> Configure Network
Configure Time
Configure Licenses
Verify Hardware health
Configure Failover
Finish Configuration and reboot
Finish Configuration
Actions:
execute) Perform the current step (Default)
skip) Skip to the next step
back) Go back to a previous step
quit) Exit the configuration immediately
Configure Network [execute]?
NOTE: In the above example, the following options can be exercised:
• Configure Network runs the network wizard which can be run separately from the net set
wizard command
• Configure Time allows configuration of NTP server, time zone and manual time, and date
settings. It is equivalent to using the commands:
◦ # time add ntpserver
◦ # time set timezone
◦ # time set utc
• Configure Licenses allows for the addition of licenses to a system by either entering the license
key or loading a license file that has been uploaded through SFTP. It is equivalent to running
the commands:
◦ # license add
◦ # license load
◦ # license show
◦ Configure Failover [execute]?
Failover is currently: disabled
Enable failover on the system:
1) Enable failover
2) Disabled failover skip) Leave failover in its current state.
• The Verify Hardware Health option runs an appliance-wide check on hardware status, software
online status, the filesystem, and StoreOnce devices. The report is presented on the CLI, and
a health check file is created in the SFTP folder, health.
• There are two options for exiting:
◦ Finish Configuration and Reboot
◦ Finish Configuration
Reboot is only required if the changes to the time setting have moved time backwards;
otherwise, no reboot is required.
190 Alphabetical List of Commands and Details