HP StoreOnce Backup System CLI Reference Guide

system reboot
Description of Command Function
Methodically shuts down and reboots the entire StoreOnce appliance. For multi-node systems, this
command can be executed only if failover is disabled.
Command Syntax
system reboot
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successfully sending the reboot request, the following is displayed:
reboot request successfully sent
Command Operation during Abnormal Conditions
• If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• If failover is not enabled, the following is displayed:
This command can not be run if failover is enabled. Please disable
failover with 'hardware disable failover'.
To see the failover status please execute 'hardware show node
status'.
Example
# system reboot
reboot request successfully sent
system reboot 185