HP StoreOnce Backup System CLI Reference Guide

net show status
Description of Command Function
Displays information on the network status.
Command Syntax
net show status [subnet <name>][port <name|all>][all]
Command Authority
Operator and Administrator
Command Object Requirements
Not applicable – no parameters exist within this command.
• NODE X – This object determines that status information will be provided for individual nodes
verses the entire cluster.
• GRP X – This object determines that status information will be provided for groups of nodes
verses the entire cluster.
Command Parameter Requirements
• subnet – This parameter shows subnetwork status.
• port – This parameter shows port status. Use all to show status for all ports.
• all – This parameter is optional. If included in the command sequence, shows the status of all
subnets or ports, respectively.
Requirements for Command Execution
• The command entry must conform to command syntax.
• All object values must be valid. See object requirements for details.
Successful Command Output
Upon successful completion of the command, information on the external network configuration is
displayed.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
Showing general network status:
# net show status
Showing subnetwork status:
# net show status subnet subnet1
Showing port status:
# net show status port eth0
Showing all port status:
# net show status port all
Showing top level status of all subnets:
net show status all
Showing subnetwork status:
net/show# status
Subnet Status Overview
net show status 141