HP StoreOnce Backup System CLI Reference Guide

net show portset
Description of Command Function
Displays the network port set
Command Syntax
net show portset <configName> <portSetName>
Command Authority
Administrator
Command Object Requirements
• configName – This object specifies the network configuration name.
• portSetName – This object specifies the port set name.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
• The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, the following message is displayed, and then the
CLI returns to the user prompt:
Command Successful
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - Did not conform to the correct command syntax for
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
net show portset config1 portset1
140 Alphabetical List of Commands and Details