HP StoreOnce Backup System CLI Reference Guide

net show config
Description of Command Function
Shows the network configuration.
Command Syntax
net show config <netlabel>
Command Authority
Operator and Administrator
Command Object Requirements
netlabel – This object defines the name of the specific network configuration to be shown. If the
object is not included in the command sequence, the parameter, all, must be included in the
command sequence.
Command Parameter Requirements
• all– This parameter is optional. If included in the command sequence, all templates in the
existing network configuration are described. If this command is not included, a network
template object must be included in the command sequence.
• list – This parameter shows a list of configuration names.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, information on the external network configuration is
displayed.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
# net show config current
----------------------
Network Name: current
Network Description: default
Write Protected: no
DNS Servers:
----------------------
Number of Networks:1
----------------------
Network: subnet_one
----------------------
IP Address: dhcp
Net Mask: dhcp
Domain Name: dhcp
Gateway: dhcp
Bonding Mode: 6 (High Availability)
Default Network: yes
Interfaces:eth0
Command Successful
# net show config all
----------------------
Network Name: Factory_Default_Configuration
net show config 135