HP StoreOnce Backup System CLI Reference Guide

net set wizard
NOTE: This command applies to single-node products only.
Description of Command Function
Runs a step-based wizard to guide you through the creation of a complete network configuration.
Command Syntax
net set wizard
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, you will be guided through a set of steps to configure
the network configuration. Upon completion, the command will return:
You have successfully configured the network settings on your StoreOnce
Appliance.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
# net set wizard
StoreOnce Network Configuration Wizard
--------------------------------------
This Wizard will guide you through the configuration of
network settings on your StoreOnce Backup System.
If you wish to make additions or modifications to an existing
network configuration without having to reconfigure all settings,
use the 'net modify' or 'net add' commands instead.
See the User Guide guide for physical port layout details.
The wizard consists of the following steps:
Step 1) Set system wide DNS server addresses (optional)
Step 2) Configure network settings for available network adapters
Step 3) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard.
The wizard consists of the following steps:
Step 1.) Set system wide DNS server addresses (Optional)
Step 2.) Configure network settings for available network adapters
Step 3.) Save and apply all network settings
Type 'quit' + ENTER at any time to exit wizard
Step 1.)Set system wide DNS server addresses (optional)
Enter a list (max 3) of DNS servers separated by commas : (eg 192.168.1.100,192.168.3.100)
192.168.1.100,192.168.3.100
Step Complete. Do you want to :
1.) Go to next step: Step 2.) (default)
2.) Go back to start of present step: Step 1.)
3.) Quit wizard and lose all settings
1
Navigation: Go to next step: Step 2)
net set wizard 131