HP StoreOnce Backup System CLI Reference Guide

net delete portset
Description of Command Function
Deletes a port set or ports in a port set.
Command Syntax
net delete portset <configName> <portSetName> [ports <ethList> ]
Command Authority
Administrator
Command Parameter Requirements
• configName – This object specifies the network configuration name.
• portSetName –This object specifies the port set name.
Command Parameter Requirements
ports – This parameter specifies a comma-separated list of ports to delete.
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, the following message is displayed, and then the
CLI returns to the user prompt:
Command Successful
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
To delete a port set from a network configuration:
net delete portset config1 portset1
To delete specific ports from a port set:
net delete portset config1 portset1 ports eth4,eth5
124 Alphabetical List of Commands and Details