HP StoreOnce Backup System CLI Reference Guide

vtl show drive info
Description of Command Function
Displays information about a given virtual drive or all the virtual drives in a given library.
Command Syntax
vtl show drive info SETX LIBX [DRVX]
Command Authority
Operator and Administrator
Command Object Requirements
• SET X – This required object defines the service set containing the virtual library drives to be
displayed. X is the numeric index of the service set. It is optional on a single-node system but
must be defined on a multi-node system. If used on a single-node system, the object must be
defined as SET1. If not defined, the capacity information is provided at the cluster level.
• LIB X – This required object is the virtual tape library that contains the drive to be displayed.
X is the numeric index of the library.
• DRV X – This optional object is the drive to be described. X is the numeric index of the library.
If not defined, information about all drives in the library is displayed.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
• The command entry must conform to command syntax.
• All object values must be valid. See object requirements for details.
Successful Command Output
Upon successful completion of the command, drive information is displayed.
Command Operation during Abnormal Conditions
If any of the command execution requirements fail, command execution terminates, the drive
information is not displayed, and one of these error messages is displayed:
• Command Failed – Did not conform to the correct command syntax “vtl
show drive info SETX LIBX [DRVX]”
• Command Failed – The service set <SETX> is invalid
• Command Failed – The service set <SETX> does not exist
• Command Failed – The library <LIBX> is invalid
• Command Failed – The library <LIBX> does not exist
• Command Failed – The drive <DRVX> is invalid
• Command Failed – The drive <DRVX> does not exist
Examples
# vtl show drive info SET1 LIB1 DRV1
Drive Object : DRV1
Library : LIB1
Library Name : Gregslib
Emulation Type : LTO4
Protocol : Fibre Channel
Serial Number : H123D45E00
WWNN : 5001438017871D33
Port : 1
FC Address : 0x9F1723
WWPN : 5001438017871D34
Command Successful
252 Alphabetical List of Commands and Details