HP StoreOnce Backup System CLI Reference Guide

◦ Command Failed – The service set <SETX> is invalid
◦ Command Failed – The service set <SETX> does not exist
◦ Command Failed – Invalid Parameter: <parameter> value: <value>
◦ Command Failed – The name must be equal to or less than 30
characters
◦ Command Failed – The interface <interface> is invalid
◦ Command Failed – The library port <LibPort> is invalid
◦ Command Failed – The library emulation <LibEmulation> is invalid
◦ Command Failed – The drive emulation <DriveEmulation> is invalid
◦ Command Failed – The drive port <DrivePort> is invalid
◦ Command Failed – The number of slots must conform to library
emulation type
◦ Command Failed – The number of slots must be between 0 and 16384
◦ Command Failed – The size of the cartridges must be 10, 25, 50,
100, 200, 400, 800, 1000, 1200, 1400, 1600 or 3200
◦ Command Failed - The number of drives must be between 0 and 192
◦ Command Failed – Drive fibre channel port defined for <interface>
interface
◦ Command Failed – Library fibre channel port defined for
<interface> interface
◦ Command Failed – iSCSI parameters defined for <interface>
interface
◦ Command Failed – Initiator log on enabled, CHAPS parameters
required
◦ Command Failed – Target log on enabled, CHAPS parameters required
◦ Command Failed – Worldwide port names defined for <interface>
interface
◦ Command Failed – Worldwide node name defined for <interface>
interface
◦ Command Failed – The number of library worldwide port names do
not equal number of library ports.
◦ Command Failed – Worldwide port name(s) are invalid
◦ Command Failed – World wide port names must consist of 16
hexadecimal characters
◦ Command Failed – The world wide port names list contains and
unsupported value: <value>
◦ Command Failed – Worldwide node names(s) are invalid
224 Alphabetical List of Commands and Details