HP StoreOnce Backup System CLI Reference Guide

system set pagecontrol
Description of Command Function
Enables or disables the page control feature.
Any command outputs information greater than one page long only shows one page at a time, if
this setting is set to on. To view the current setting, execute the system show config command.
As with system set clioutput, the command is reset on each new terminal session.
Command Syntax
system set pagecontrol {on|off}
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
on/off – This required parameter defines the state of page control. On means the page control
feature is enabled, and off means the page control feature is disabled.
Requirements for Command Execution
• The command entry must conform to command syntax.
• The parameter value must be valid; see the parameter description for details.
Successful Command Output
Upon successful completion of the command, the following is displayed:
Paging of CLI output is set to [on or off] (as defined during command execution)
Command Successful
Command Operation during Abnormal Conditions
• If any of the command elements (system, set, pagecontrol, ) are misspelled, the following
is displayed:
element: command not found
• If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
# system set pagecontrol on
Paging of CLI output is set to off
Command Successful
192 Alphabetical List of Commands and Details