HP StoreOnce Backup System CLI Reference Guide

system set config
Description of Command Function
Runs a step-based wizard to guide you through a complete series of system configuration steps:
• Configure network
• Configure time
• Configure licenses
• Verify hardware health
• Configure failover
NOTE: Configure failover only applies and is only available for configuration for multi-node
products. This step in the wizard is eliminated when performing a single-node product
configuration.
• Finish configuration and reboot
• Finish configuration
NOTE: This command is intended to act as a setup wizard for installing new StoreOnce systems
and groups together operations that would normally be performed by other CLI commands that
are useful when first setting up a system.
.
Command Syntax
system set config
Command Authority
Administrator
Command Object Requirements
Not applicable–no objects exist within this command
Command Parameter Requirements
Not applicable–no parameters exist within this command. (Any parameters are entered within the
wizard rather than appended to the command.)
Requirements for Command Execution
The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, system configuration setup is complete.
Command Operation During Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
NOTE: This example applies to multi-node products (failover configuration is not supported in
single-node).
$> system set config
Please ensure all nodes have joined the cluster prior to running this command.
Found 2 nodes. All nodes operational.
failover disabled.
system set config 189