HP StoreOnce Backup System CLI Reference Guide

system enable failover
NOTE: This command applies to multi-node products.
Description of Command Function
Enables the failover feature on the StoreOnce appliance. It is a direct map to the command sequence
hardware enable failover all (see “hardware enable failover” (page 67)). For the initial
release, this command only enables failover for the entire appliance. In following releases, the
command is updated to enable failover for given service sets.
Command Syntax
system enable failover
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
• The command entry must conform to command syntax.
• Failover must already be disabled.
Successful Command Output
Upon successful completion of the command, the following is displayed:
failover enabled
Command Operation during Abnormal Conditions
• If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• If failover is already enabled, the following is displayed:
Command Failed - failover is already enabled
Example
# system enable failover
failover enabled
system enable failover 183