HP StoreOnce Backup System CLI Reference Guide

nfs show config
Description of Command Function
Displays information on the NFS server configuration.
Command Syntax
nfs show config [SETX]
Command Authority
Operator and Administrator
Command Object Requirements
SET X – This object defines an individual service set. X is a unique numeric index. This object is
required for a multi-node system and optional for a single-node system. If it is omitted for a
single-node system, it defaults to SET1. If the object is specified (either for a multi-node or single-node
system), it must be specified in the exact position as given by the command syntax, i.e., it must
immediately follow the config command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
• The command entry must conform to command syntax.
• The service set SETX object must be valid.
Successful Command Output
Upon successful completion of the command, the configuration information of the NFS server is
shown.
Command Operation During Abnormal Conditions
If any of the command execution requirements fail, command execution terminates, the host
properties are not modified, and one of these error messages is displayed:
• Command Failed - The command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
• Command Failed - Invalid number of arguments
• Command Failed - Description (desc) not specified
• Command Failed - Service set ID (SETX) not specified
• Command Failed - Invalid parameter ‘X’
Example
# nfs show config
Host Name Description
* Allow any host
10.0.0.5 Main Server
10.0.0.6 Other Server
10.1.2.* Test Workstations
Command Successful
152 Alphabetical List of Commands and Details