HP StoreOnce Backup System CLI Reference Guide

Step 2.)Configure network settings for available network adapters
Select the type of configuration for this subnet :
1.) Single port (default)
2.) Bonded ports (note ports must be the same speed to bond
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth0 and eth1 (1 Gig) (default)
2 = eth0 and eth2 (1 Gig)
3 = eth0 and eth3 (1 Gig)
4 = eth1 and eth2 (1 Gig)
5 = eth1 and eth3 (1 Gig)
6 = eth2 and eth3 (1 Gig)
7 = eth4 and eth5 (10 Gig)
8 = eth4 and eth6 (10 Gig)
9 = eth4 and eth7 (10 Gig)
10 = eth5 and eth6 (10 Gig)
11 = eth5 and eth7 (10 Gig)
12 = eth6 and eth7 (10 Gig)
-->12
<--Bonding: eth6 and eth7 (10 Gig)
Select the desired bonding mode :
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->1
<--Bonding Mode: Mode 1 - Active Passive Bonding
Is this subnet on a Virtual LAN?
1 = Not VLAN (default)
2 = VLAN
-->2
<--VLAN/Not VLAN: VLAN
Enter VLAN tag (an integer between 2 and 4094 inclusive) :
-->444
<--VLAN Tag: 444
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
Do you want to configure a static default gateway for this subnet or get the gateway information from DHCP?
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually
-->1
<--Gateway: Gateway obtained from DHCP server
Do you want to configure the network domain name or get the domain name from DHCP?
1 = Domain name obtained from DHCP server (default)
2 = Set domain name manually (e.g. mydomain.local)
-->1
<--Domain Name: Domain name obtained from DHCP server
----------------------
Network: subnet_1
----------------------
IP Addresses: dhcp
Net Mask: dhcp
Domain Name: dhcp
Gateway: dhcp
VLAN tag: 444
Port Set: portset_1 with these interfaces: eth6 eth7
Bonding Mode: 1 (Active Passive Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new port set
3 = Yes - on the same VLAN port set
-->3
132 Alphabetical List of Commands and Details