HP StoreOnce Backup System CLI Reference Guide

net add ipaddr
Description of Command Function
Adds a new IP address to a subnet in a configuration.
Command Syntax
net add ip addr <netlabel> <sublabel> <iplist>
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
• netlabel – This parameter specifies the network configuration name.
• sublabel – This parameter specifies the subnet name.
• iplist – This parameter specifies the comma-separated list of IP addresses to add.
Requirements for Command Execution
• The command entry must conform to command syntax.
Successful Command Output
Upon successful completion of the command, the following message is displayed, and then the
CLI returns to the user prompt:
Command Successful
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
Add two new IP addresses to subnet1 in config1:
net add ipaddr config1 subnet1 10.0.1.11,10.0.1.12
112 Alphabetical List of Commands and Details