HP Store Once Backup System 2700, 4500 and 4700 Installation and Configuration Guide

If you select a bonded configuration for your network, the network wizard provides a number of
permutations for a portset, depending upon the availability and number of 10GbE ports. The
example below is for an HP StoreOnce 4500 or 4700 Backup system, which has two 10GbE
ports, and only one 10 Gig bonding option..
Select bond configuration :
1 = eth0, eth1 (1 Gig) (default)
2 = eth0, eth2 (1 Gig)
3 = eth1, eth2 (1 Gig)
4 = eth0, eth1, eth2 (1 Gig)
5 = eth0, eth3 (1 Gig)
6 = eth1, eth3 (1 Gig)
7 = eth0, eth1, eth3 (1 Gig)
8 = eth2, eth3 (1 Gig)
9 = eth0, eth2, eth3 (1 Gig)
10 = eth1, eth2, eth3 (1 Gig)
11 = eth0, eth1, eth2, eth3 (1 Gig)
12 = eth4, eth5 (10 Gig)
IMPORTANT: Once you have created a portset, the ports that you have defined for that portset
are no longer available for use in other portsets.
Physical subnets are one-to-one; each physical subnet is configured on one portset only. However,
multiple virtual subnets (VLANs) may be attached to a single portset (up to a maximum of 128).
See VLAN subnets with StoreOnce Backup (page 38).
Identifying network ports available
All systems have four 1GbE ports that are identified as eth0 (LAN port 1) and eth1, eth2 and eth3
(LAN ports 2, 3 and 4).
HP StoreOnce 4500 and 4700 Backup systems have an additional two 10GbE ports that are
identified as eth4 and eth5.
If you do not know what ports are available on your system, use the following StoreOnce CLI
command:
# net show ports
This command will display the port layout of the StoreOnce Backup system with details of the ports.
NOTE: The physical layout is reflected in the |link n| positioning of the output. Looking at
the rear of the HP StoreOnce appliance:
• eth3 = LAN port 4, eth2 = LAN port 3, eth1 = LAN port 2, eth0 = LAN port 1
• eth4 (right) and eth5 (left) = 10GbE port on top card
# net show ports
=============================== Node X ==============================
| || |
| || | Port 2 | Port 1 | 10GbE |
| || | | | |
|============ card 1 ============= ============ card 2 ============ |
| || |
| || |
| |
||Link4|Link3|Link2|Link1| | Ilo | |
======================================================================
Port Number OS Hardware Bonds 1G/10G
P1 eth0 - 1 Gig
P2 eth1 - 1 Gig
36 Network configuration, understanding the StoreOnce networking concepts