HP StoreOnce B6200 Maintenance and Service Guide (February, 2014)

2 Quick reference — configurable parts and replacement
process checklists
Node — HP ProLiant DL380 G7 Server
For more details see Maintaining server (node) components (page 22).
Configurable parts
When replacing server parts use the HP ProLiant DL380 G7 Maintenance and Server guide, but
be aware of the following HP StoreOnce Backup System specific information:
Table 1 Server configurable parts
CommentsDescriptionPart numberPart
8GB PC3-10600R,512Mx4501536-001DIMM
Only 2 are installed. If one
fails, the system will continue
500GB 7.2K 2.5" 6G SAS
Hard Drive
508009-001HDD
to function correctly. The
replacement disk invokes the
Smart Array Automatic Data
Recovery (ADR) feature to
rebuild the replaced drive.
1200W power supply579229-001PSU
x5680 3.3MHz614739-001CPU
MAC addresses for 10GbE
network ports must be
configured
NC550 or NC552 sfp
10GbE card
586444-00110Gb ethernet card
SC08e SAS HBA card617824-001SAS card
82Q FC Q-Logic Dual 8GB
FC card
489191-001FC card
BIOS, iLO3 settings and
MAC addresses for 1GbE
DL380 G7 motherboard599038-001Motherboard
network ports must be
configured
512MB flash backed write
cache
578882-001Flash Backed Write Cache
IMPORTANT: When replacing the motherboard (or individual cards) be sure to always replace
cards into the same slot from which they were removed. It is also important to set BIOS and iLO
settings. See BIOS settings (page 24), Reconfiguring iLO (page 23) and Reconfiguring 1GbE MAC
addresses (page 25).
Server component replacement process
PSU and HDD
These two items are hot-swappable. Order the correct replacement part as shown in the table on
the previous page and follow the instructions in the HP ProLiant DL380 G7 Maintenance and Server
guide.
IMPORTANT: If changing a power supply, care must be taken to ensure that there is no interference
with any of the PDUs and power cabling.
Node — HP ProLiant DL380 G7 Server 9