HP StoreOnce B6200 Maintenance and Service Guide (February, 2014)

4. Press <F10> to save the changes, and exit.
BIOS settings
IMPORTANT: Configure the BIOS settings BEFORE connecting the FC, network and SAS cables
to the server.
1. Ensure that you have the latest BIOS revision installed, see table below. Install the latest BIOS
revision from the relevant product site. All BIOS revisions can be found at http://www.hp.com/
support/downloads (under Storage — Disk Storage Systems — Disk to disk Backup — HP
StoreOnce Backup Systems).
2. Reboot the system. During the system BIOS boot process, when the prompt to Press F9 is
visible, press the F9 key to enter the RBSU (ROM-based Setup Utility) or BIOS Setup.
3. Change the options, as shown in the following table.
24 Maintaining server (node components) — HP ProLiant DL380 G7 Server