HP D2220sb Storage Blade User Guide

Setup 18
CAUTION: Thermal regulation is maintained only when the drive drawer is closed. The drive
drawer open alarm is triggered under the following conditions:
•
A slow beep and flash (1 every 5 seconds) indicate that the drive drawer is open. The drives
are not fully protected by system air flow.
• A fast beep and flash (2 per second)—To avoid drive damage or data loss and storage blade
shutdown, close the drive drawer immediately.
When the drives reach critical temperatures, the system shuts down.
1. Open the drive drawer.
IMPORTANT:
The drive drawer is not fully extended until the rail lock is engaged. To engage the
rail lock, extend the drive drawer approximately 2.54 cm (1 inch) past the initial resistance.
2. Remove the drive blanks as needed.
CAUTION: To prevent improper cooling and thermal damage, do not operate the D2220sb or
the enclosure unless all enclosure device bays and the first three storage drive bays are populated
with either a component or a blank.