HP D2220sb Storage Blade Maintenance and Service Guide

Removal and replacement procedures 39

Remove the drive drawer.

To replace the component, reverse the removal procedure.

CAUTION: Be sure the pass-through board is fully installed before installing the drive drawer.

Otherwise, damage may occur to the pass-through board or drive drawer.

Enclosure release latch assembly

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

CAUTION: Do not operate the D2220sb with the access panel open or removed. Operating the

D2220sb in this manner results in improper airflow and improper cooling that can lead to thermal

damage.

To remove the component:

1. Back up all data on the D2220sb.

2. Power down the partner server blade (on page 21).

3. Remove the D2220sb (on page 21).

4. Remove all drives ("Remove the drives" on page 23).

5. Remove the access panel (on page 26).

6. Remove the drive drawer ("Drive drawer" on page 37).

7. Remove the bottom drive drawer slide assembly from the chassis.