HP StorageWorks D2200sb PCIe Storage Blade Maintenance and Service Guide

Removal and replacement procedures 39
8.
Remove the drive drawer.
To replace the component, reverse the removal procedure.
CAUTION: Be sure the pass-through board is fully installed before installing the drive drawer.
Otherwise, damage may occur to the pass-through board or drive drawer.
Drive drawer slide assemblies
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: Do not operate the storage blade with the access panel open or removed. Operating
the storage blade in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
To remove the component:
1. Back up all data on the storage blade.
2. Power down the partner server blade (on page 22).
3. Remove the storage blade (on page 22).
4. Remove all drives ("Remove the drives" on page 24).
5. Remove the access panel (on page 26).
6. Remove the drive drawer ("Drive drawer" on page 37).
7. Remove the slide assemblies from the drive drawer: