HP StorageWorks Continuous Access EVA Administrator Guide (T3687-96043, December 2005)

Perform one of the following steps on the destination host, depending on whether or not you are running
LifeKeeper 4.4.3.
1. If you are running LifeKeeper 4.4.3, proceed to step 2. If you are not running LifeKeeper, perform
the following steps:
a. Issue the following command to make the volume known to the system:
vgimport VolumeGroupName PhysicalVolumePath
Example: vgimport vg01 /dev/sda1
b. Mount the file systems.
Example: mount –t reiserfs /dev/vg01/lvol1 /mounts/lvol1
c. StarthostI/O.
d. If the verification path is turned off, issue the following command:
spmgr set –p on
2. If you are running LifeKe eper 4.4.3 clusters:
a. If this is the first time LUN s are being presented to the destination host, you must build the
resource hierarchies for each new LUN presented (see the documentation on the LifeKeeper CD).
b. Bring your resources "out of service" with the LifeKeeper GU I.
c. StarthostI/O.
d. If the verification path is turned off, issue the following command:
spmgr set –p on
52
Operatingsystemspecifics