HP P6000 Continuous Access Implementation Guide (T3680-96431, August 2012)

Table 8 Configuration form (continued)
(default = \Hosts\)Folder name:
Host name:
Operating system:
WWN:For each HBA port:
Virtual disk information
(default = \Virtual Disks\)Folder name:
Virtual disk name:
Disk group:
Size:
(Vraid0, Vraid1, Vraid5)Redundancy level:
(Mirrored write-back, unmirrored write-back)Write cache policy:
(On, off)Read cache policy:
(Read/write, read-only)Read/write permissions:
(default = 0)OS unit ID:
(None, Path A FO, Path A FO/FB, Path B FO, Path B FO/FB)Preferred controller
Host name:Presentation:
LUN:
DR group information
Array name:Source:
Virtual disk members:
Array name:Destination:
Virtual disk members:
Failsafe mode: (disabled, enabled)Parameters:
Write mode: (synchronous, enhanced asynchronous, or
basic asynchronous)
Destination mode: (none, read-only)
Upgrading controller software
The following documents provide detailed information on upgrading controller software. Make
sure you have these documents available before performing the upgrade.
• Updating Product Software Guide for your array model and controller software version. You
can access this document from the Manuals page of the HP Business Support Center website:
http://www.hp.com/support/manuals.
In the Storage section, click Disk Storage Systems and then select your product from EVA Disk
Arrays.
• HP P6000 Enterprise Virtual Array Compatibility Reference
Upgrading controller software 127