Altiris RapiDeploy Imaging from a USB Storage Device

5. For static IP, type the IP address next to the following line: Address= .

6. After you have made all required changes, save the file and close.

7. After you correctly execute these steps, you can execute the imaging task. The command line for exe-

cution is: rdeployt -md -fc:\*.img -cfgfile:c:\aclient.cfg -d2, where

• RdeployT = Application

• -MD = Download the image (vs. Upload the image)

• -f = the image file

• -cfgfile: = the configuration file location

• -d2 = Enumerates the disk to image. This is disk 2, because when the USB storage device is

plugged in, the BIOS enumerates the USB device as disk 1, making the hard disk number 2.

NOTE: If you used the correct procedure to create the disk image and the target thin client is an XPe unit,

you must re-enable the Microsoft Enhanced Write Filter after the imaging job is complete.

Aclient.cfg

The following lists the contents of the Aclient.cfg file:

[Global] [Bootwork]

MACAddrList= SetTransportInfo=False

Serial-Number= SetIPInfo=False

UUID= [ConfigSettings]

NSMachineGuid= UpdateSettings=False

Reboot=False UpdateAllSettings=False

Status-Code=0 [Security]

Status-Module=AClient Secure=

SIDgenCount=0 [TCP/IP]

TaskSequence=0 MACAddress=

ScheduleId=0 Description=

Remove=False VendorID=0

Config=None DeviceID=0

[License] PCIFunction=0

Sysprep2KLicense= PCIDevice=0

LicenseNumber= PCIBus=0

RegOrganization= WINS-Server1=0.0.0.0

RegUser= WINS-Server0=0.0.0.0

Prompt=False WINS-Server-Count=2

[Networking] WINS-Enabled=False

DSDomainController= SetWINSInfo=False

DSOrganizationalUnit= DNS-Server2=0.0.0.0

ChangeSID=False DNS-Server1=0.0.0.0

ComputerName= DNS-Server0=0.0.0.0