HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
The device defined in the disk configuration definition file exists on a
storage system that differs from the storage system in the disk
configuration definition file. For this reason, an NG Scan cannot be
executed.
Check the device address domain ID specified in the disk configuration
definition file or the Set Defaults panel. For details about the NG Scan,
see the HP XP7 for Business Continuity Manager Software User Guide.
devn (hexadecimal number)
Device number defined in the disk configuration definition file
sn
Serial number of the storage system on which the device indicated
by devn actually exists
The device indicated by devn in the
disk configuration definition file is on
a storage system that differs from sn.
YKZ415E MSG
SC=48 RC=48
This storage system does not allow Continuous Access data
differential-data management units to be specified.
Use a device
#2
that allows Continuous Access data differential-data
management units to be specified. Also, if scanning was not performed
after the storage system microcode was replaced, perform another
scan.
SUPFnc (hexadecimal number)
Value for the version of the storage system support function used
in the copy group (minimum)
#1
If this message is output while the YKLOAD command is being ex-
ecuted, the RC is 44.
#2
Continuous Access data differential-data management units can
be specified on storage systems with the following versions of the
storage system support function:
• XP12000s with a storage system support function version of X'11'
or later
• XP24000s with a storage system support function version of X'20'
or later
Copygroup SUPFnc does not sup-
port CA Map (DIF UNIT).
YKZ416E MSG
SC=36 RC=36
#1
The command cannot be executed for Continuous Access copy groups
with the HyperSwap attribute.
Execute the PPRC copy pair operation from TPC-R.
This command is invalid for Continu-
ous Access Copy Groups linkaged
with HyperSwap.
YKZ417E MSG
SC=48 RC=48
A resynchronization that reverses the copy direction cannot be per-
formed with the OPENMFUPDATE parameter specified. (The OPENMFUP-
DATE parameter is used to modify the Open/MF Consistency attribute.)
OPENMFUPDATE cannot use with
reverse-resync.
YKZ418E MSG
SC=48 RC=48
The YKQEXCTG command cannot be executed because the copy group
container does not have an EXCTG ID. This command is valid only for
copy group containers with an EXCTG ID. Confirm that the command
can be executed on the copy group, and then re-execute the command.
This command is valid only for copy
group containers with EXCTG ID
specified.
YKZ419E MSG
SC=48 RC=48
Messages212